Auto restart if Pi hangs

Support for the UPS PIco HV3.0A, HV3.0B and HV3.0B+, as also Terminal Block products, SD images also for updated hardware HV3.0A/B/B+
User avatar
RDK_Pi
Posts: 53
Joined: Sun Nov 22, 2015 3:12 pm

Re: Auto restart if Pi hangs

Post by RDK_Pi » Sat Aug 05, 2017 8:14 am

PiMaster.....I will have to move the Gold Plated pin on my UPS PIcoHV3.0A from P3 to P2. Do you have any suggestions on how to do this without ruining the pin? Thanks...RDK
User avatar
Pimaster
Site Admin
Posts: 1615
Joined: Fri Sep 14, 2012 9:50 am

Re: Auto restart if Pi hangs

Post by Pimaster » Sun Aug 06, 2017 4:09 pm

Hi,
The following solutions are available on my opinion
1. A brutal solution
- cut the pin on the position RPi 3
- solder a new one on the Position RPi 2

2. A civilized solution
- de-solder the pin from the position RPi 3 (not so difficult - just heat on the top side and remove from the bottom)
- solder the same pin one on the Position RPi 2 (follow the manual where it is very detailed described and shown on photos)

3. A dirty solution
- cut the pin on the position RPi 3
- solder a cable to the place of the Gold Pin RPi 2, and the second end of this cable to the Raspberry Pi (suggested only if really can not solder properly the pin)
Warmest Regards
PiM
---
Designing with Mentor Graphics PADS - www.pads.com
Please read and follow the PiForum rules
http://www.forum.pimodules.com/viewtopic.php?f=13&t=196
---
User avatar
RDK_Pi
Posts: 53
Joined: Sun Nov 22, 2015 3:12 pm

Re: Auto restart if Pi hangs

Post by RDK_Pi » Sun Aug 06, 2017 4:17 pm

OK, I will give it a try....RDK
Post Reply